aerofly RC 10 elevator trim?

    aerofly RC 10.01.01, iMac Sequoia 15.2, Jeti ds-24

    Jeti ds-24 supports neither trimming nor model programming when using aerofly. It appears Jeti sends to aerofly only raw stick, slider and switch positions.

    With Hawk jet, I found that half throttle, level flight elevator trim can be accomplished by adjusting Servo Left/Right Elevator Min, Max, and Offset as well as CG configuration values.

    It is possible to configure several different elevator trims in aerofly?

    For example, I would like to try a second, slower speed elevator trim appropriate for a no wind, no turbulence landing approach. Another example, I would like to try elevator trims appropriate for knife edge and vertical uplines and downlines.

    Zitat von Mike Schuster

    Jeti ds-24 supports neither trimming nor model programming when using aerofly. It appears Jeti sends to aerofly only raw stick, slider and switch positions.

    That sounds weird for a transmitter this expensive. Before trying to do this in the sim, I would exhaust all options, there are also ways to have a wireless connection to the PC with a Receiver-like Dongle I think, so the PC is receiving the signal essentially like any other model

    Thanks momentmal, good idea, so far not found a receiver-like dongle for Jeti. But no worries, I now think that the other trims I had in mind will not be helpful, as they vary with airspeed and attitude. So I now believe that the single level flight trim I found by adjusting the model configuration suffices.